Cubierta of the flotador of the DELL`ORTO carburettor for DRT SI 20,20-26,26 for Vespa

Descripci n

Cubra del flotador del carburador DELLʻORTO por DRT SI 20,20-26,26, para Vespa 125 TS / 150 Sprint V / Rally / PX80-200 / PE / Lusso / T5 with el 5.2mm aguja del flotador, para MALOSSI 166 / DR / Pinasco / POLINI 177, PX200 La cubierta DELL 'Orto flotante est ndar IS 20.20H habitaci n / 24.24H is an especial gift and an actualizaci n perfecta para todos los carburadores SI 20-24. With on aguja del flotador 5,2 mm that resuelve the problem of captar a plena capacidad. La cubierta flotante DELL ORTO `habitaci n que ha sido revisada por DRT tambi n est destined to all vespisti cuyas manos tienden to ponerse nervioso en el embrague during the conducci n en carretera de descenso. It holds a v lvula m s grande y a aguja del flotador with 5,2 mm. El agujero de 0,7 mm means sufficient mezcla siempre fluye a trav s de a todo gas. En estas cubiertas, el orificio de suministro desde el dep sito hasta el chorro principal debe ser perforado hacia fuera de 1,5 mm to 1,8 mm (PX177) or 2,0 mm (PX200). This tapa de la c mara de flotaci n with the aguja 5,2 mm flotador resuelve el the problem of the toma de pist n complete with the accelerator. Please drill the top orifice from 1,5 mm to 1,8 mm (PX177) or 2.0 mil metros (PX200).

Carburetor floating cover DELLʻORTO by DRT SI 20.20-26.26, for Vespa 125 TS / 150 Sprint V / Rally / PX80-200 / PE / Lusso / T5 with float needle 5,2mm, for MALOSSI 166 / DR / PINASCO / POLINI 177, PX200 standard. The DELL ʻORTO SI floating lid 20.20H / 24.24H chamber is a special treatment and perfect upgrade for all 20-24 SI carburettors. With its 5,2 mm spiked float it solves the problem of grasping at full capacity. The DELL ʻORTO floating lid has been revised by DRT and is also intended for all Vespa riders whose hands tend to get nervous on the clutch when riding downhill. It has a larger valve and a floating needle with 5,2mm. The 0,7mm hole means enough mix always flows through at full throttle. On this lid, the feed hole from the bowl to the main jet should be drilled out 1.5mm to 1,8mm (PX177) or 2,0mm (PX200).